Auto Gas Releasing Control Panel
PE-GRP 200/400 Series
Fire Hazard Solution
* Fire Alarm Panel Complied to MS 1745:Part 2: 2004
* Bomba Approved
1. IEC 61000-6-1
2. IEC 61000-6-2
3. IEC 61000-6-3
4. IEC 61000-6-4
Program Auto Gas Releasing Control Panel GRP 200/400 Series manufactured in accordance to MS 1745-2 : 2004 and conformed to local CIFS requirement.
PE-GRP 200/400 series is a micro processor programmable user friendly control panel with a digital ammeter, voltmeter and a countdown timer displayed on the front panel. Count down timer is pre-set for 30 seconds upon two (2) activated zone. Timer can be program to required specification.
Built-in power pack with an intelligent charger which allow to charge up a set of complete flat 24 volts battery and automatically cuts off charging once battery fully charge.
This controls and indications are housed in a compact enclosure finished with signal red polyester epoxy powder paint. Indoor and outdoor type of enclosure are available.
Standard Features
- Power Source Indicators
- Power Failure Indicators
- Zone Fire, Fault and Isolate Indicators
- Bell Isolate Switch and Indicator
- Gas Isolate Switch and Indicator
- Fault Buzzer Mute Switch
- Master Reset Switch
- Test Lamp Switch
- Test Battery Switch
- Earth Fault Supervisory
- Built-in Delay Discharge Timer (Programmable)
New Features
- GAS Abort Function (Optional)
- Digital Voltmeter & Ammeter
- Intelligent Battery Charger
- Digital Countdown Timer
- Common Fault Contact
- Low Pressure Indicator
- Dimensions
| No. of Zones | Model | Indoor | Outdoor |
|---|---|---|---|
|
2 |
PE - GRP 200i |
430 x 370 x 195 |
435 x 410 x 195 |
|
3 |
PE - GRP 400i |
550 x 390 x 195 |
550 x 430 x 195 |
| Technical Data | |
|---|---|
|
Power Supply |
240V AC 50/60Hz |
|
Operating System |
24V DC |
|
Battery Cut Off |
18V |
|
Intelligent Charger (S1) |
0.67A - 1.3A @ 30% |
|
Intelligent Charger (S5) |
1.2A - 1.8A @ 100% |
|
End of Line |
8K2 Ohms |
|
Auxiliary Output |
24V, 2 Amp |
|
Alarm Signal |
N/O Contact |
|
Gas Discharged Signal |
N/O Contact |
| Standby Mode | |
|---|---|
|
Master |
75mA |
|
Per Zone (c/w Detectors) |
5mA |
|
Flashing Light (Green LED) |
25mA |
| Alarm Mode | |
|---|---|
|
Master |
140mA |
|
Per Trigger. Zone |
50mA |
|
Output Devices |
150mA |
|
Flashing Light (Red LED) |
25mA |
|
Per Bell |
30mA |
Catalogue Download
Let’s Talk About Your Project
We stay on top of our industry by being experts in yours.
